Installing a Brick Paver Walkway or Common Bricks

The use of Bricks or Pavers to develop a sidewalk or outdoor patio complements a house in a way that is unmatched. In addition, setting up a Brick or Paver pathway does not necessarily require a pro.

The secret to installing a Brick or Paver Walkway is to very first properly prepare the location where the bricks/pavers are to be set up. In addition, string lines ought to be strung on each side of the walkway.
Once the area has been dug, 3/4" gravel stone ought to be laid in and tamped down firmly. Then 2" of sand, or stone dust ought to be topped the gravel. Once again the sand/stone dust must be tamped down. Stone dust is chosen. The height between the tamped down sand and the stringline should equate to the density of the brick or paver.

Now that you have a steady base, place a 1" pipeline or ledger board the length of the walkway on either side of the walkway. Utilizing a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will produce a level surface location to lay the bricks/pavers.

Now place on the level sand/stone dust strips of plastic brick borders. Set up an operate on both sides of the ready location. These strips will function as your sidewalk border and help to maintain the integrity and shape of the sidewalk. You can get these plastic strip borders at many house enhancement stores. The strips should be anchored down with 12" galvinized nails. You must sink these nails into the ground and through the strips every foot.

The secret to laying the bricks/pavers is to ensure that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will once again assist maintain the integrity of the pathway.

Undoubtedly bricks/pavers will require to be cut or divided when building the pathway. Unless you want to purchase or rent an expensive wetsaw, I would recommend purchasing a basic brick/paver splitter. It is generally a chisel with a broad end that is the width of the bricks/pavers. To in fact cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you wish to break the brick. Then using a hammer strike the butt end of the sculpt strongly. You may need to do this a number of times. You may also want to flip the brick/paver over and strike the other side of the brick using the hammer and chisle. Within one or 2 strikes the brick/paver should break easily. If your pathway has curves you will need to buy/rent a wetsaw.

After setting up the bricks, develop up click here the outdoors edges with additional sand, and then shovel in the topsoil and load down securely.
Spread stone dust over the new walkway and sweep into the cracks. This will finish the interlocking of the bricks and assist to get rid of any weed growth.


In addition, setting up a Brick or Paver pathway does not necessarily need a pro. The key to setting up a Brick or Paver Walkway is to first effectively prepare the location where the bricks/pavers are to be installed. Now that you have a steady base, position a 1" pipeline or journal board the length of the pathway on either side of the sidewalk. These strips will act as your sidewalk border and help to keep the stability and shape of the walkway. Inevitably bricks/pavers will need to be cut or split when constructing the walkway.

Leave a Reply

Your email address will not be published. Required fields are marked *